Dometic 3000 Owner's Manual page 13

TROUBLESHOOTING
SYMPTOM 3. Flush valve will not close.
Condition/Procedure
Mode Switch is in SERVICE
position:
Foreign object prevents the flush
valve from closing and the safety
circuit locked flush valve in open
position:
Check for error code at "DO NOT
FLUSH" status light.
Check the voltage output to
the flush valve motor at jack 6,
pins 9 and 10 on the control
module as follows:
SYMPTOM 4. Water will not enter toilet bowl during a flush and when the flush handle is raised
in the "Add Water" position.
Procedure
Place the Water Level switch
in the LOW position. Check
the "WATER VALVE" status
light while pressing the flush
handle down:
SYMPTOM 5. Water will not enter toilet bowl when the flush handle is raised in the "Add Water"
position.
Procedure
Flush the toilet, then place
the Water Level switch in the
LOW position. Then check
the "LO LEVEL" status light
while raising the flush handle:
SYMPTOM 6. Water Level switch has no effect on water level in the "Low" or High" position.
SYMPTOM 7. Flush valve will not open when Mode Switch is in the "Service" position but opens
during a normal flush cycle.
(cont'd)
Corrective Action
• Return switch to the "Normal" position.
• Reset the control circuit by putting the Mode Switch in the SERVICE
position temporarily, then returning to the NORMAL position. If the
flush valve did not close, go to next step.
• If showing error, follow the instructions in the Error Code Corrective
Procedures section.
• Pull the control module out as far as the control cables will allow.
Locate jack 6 at the bottom of the control module.
• Remove the green wire from pin 5.
• With DC voltmeter test leads across pins 9 and 10, flip the Mode
Switch between the SERVICE and NORMAL positions. If voltage is
present for about two seconds in the NORMAL position, the flush
valve motor or related wiring is defective.
• If voltage is not present, replace the control module.
Corrective Action
• If the "WATER VALVE" status light comes on, the water valve filter
screen may be plugged with debris, or the water valve or its related
wiring is defective.
• If the "WATER VALVE" status light remains off, replace the control
module.
• If voltage is not present, replace the control module.
Corrective Action
• If the "LO LEVEL" status light comes on, replace the control module.
• If the "LO LEVEL" status light does not come on, the flush switch or
its related wiring is defective.
Corrective Action
• Replace control module.
Corrective Action
• Replace control module.
13