Breaking In The New Tires - HYOSUNG GT250 FI Owner's Manual

★ ★ BREAKING IN THE NEW TIRES
New tires need proper break-in to assure
maximum p e r f o r m a n c e , just as the
engine does.
Wear in the tread surface by gradually
increasing your cornering lean angles
over the first 160 km (100 miles) before
attempting maximum performance. Avoid
hard acceleration, hard cornering, and hard
braking for the first 160 km (100 miles).
WARNING
Failure to perform break-in of the tires
could cause tire slip and loss of control.
Use extra care when riding on new tire.
Perform proper break-in of the tire as
described in this section and avoid hard
acceleration, hard cornering, and hard
braking for the first 160 km (100 miles).
★ ★ ALLOW THE ENGINE OIL TO
CIRCULATE BEFORE RIDING
Allow sufficient idling time after warm
or cold engine start up before applying
load or revving the engine. This allows
time for the lubricating oil to reach all
critical engine components.
★ ★ OBSERVE YOUR FIRST, AND
MOST 1,000 km SERVICE
The 1,000 km (600 miles) service is the
most important service your motorcycle
will receive.
During break-in procedures, all of the
engine components will have worn in
and all of the other parts will have seated
in.
All adjustments will be restored, all
fasteners will be tightened, and the dirty
engine oil and engine oil filter will be
replaced.
Timely performance of the 1,000 km
(600 miles) service will ensure optimum
service life and performance from the
engine.
Service should may be peformed before
1,000 km (600 miles) on motorcycle that
are used under severe conditions.
The 1,000 km (600 miles) service should
be performed as outlined in the
INSPECTION AND MAINTENANCE
section of this Owner's Manual. Pay
particular attention to the 『 『 CAUTION』 』
and 『 『 WARNING』 』 in that section.
45
CAUTION
CAUTION