Fuse; When The Engine Refuses To Start; Trouble Shooting; Ignition System Check - HYOSUNG GT250 FI Owner's Manual

◉ ◉ FUSE
The fuse box is located behind the rear
seat. If the engine suddenly stops while
running or any electrical system fails to
operate then the fuse must be checked.
In case a fuse blows there is 30A and 15A
for main spare fuse.
CAUTION
Never use other than specified 30A or

fuse.

Installing a fuse of incorrect rating may
seriously damage the electrical system.
You should consult your Hyosung
dealer or a qualified service mechanic
immediately.
WHEN THE ENGINE REFUSES
◉ ◉ TROUBLE SHOOTING
If the engine refuses to start, perform the
following inspections to determine the
cause.
● ● Ignition System Check
①
Remove a spark plug and reattach to the
spark lead.
②
While holding the spark plug firmly
against the crankcase of the engine,
push the starter switch with the ignition
switch in the " ON " position, the engine
stop switch in the "
transmission in neutral, the side stand up
and the clutch disengaged.
If the ignition system is operating
properly, a blue spark should jump a
cross the spark plug gap.
③
If there is no spark, clean the spark plug.
Replace it if necessary. Retry the above
procedure with the cleaned spark plug
or new one.
④
If there is still no spark, consult your
Hyosung dealer for repairs.
WARNING
Performing the spark test improperly
can cause a high voltage electrical
shock or an explosion.
Avoid performing this check if you are
not familiar with this procedure, or if you
have a heart condition or wear a
pacemaker. Keep the spark plug away
from the spark plug hole during this test.
68
TO START
" position, the