On/Off Reset Board; Diskette/Cd-Rom Drive - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

To remove the LED board:
1. Turn off server and disconnect all external cables and power cords.
2. Remove the cover. See "Removing the cover and bezel" on page 42.
3. Disconnect the LED board cable from the system board, connector (J39).
4. Remove the two screws 1 .
5. Carefully slide out the board 2 .

On/off reset board

Note: Before beginning, read "Safety information" on page 109, "Before you begin"
To remove the on/off reset board:
1. Turn off server and disconnect all external cables and power cords.
2. Remove the cover. See "Removing the cover and bezel" on page 42.
3. Disconnect the cable from the system board, connector (J11).
4. Remove the screw 1 .
5. Gently pull off the board 2 .

Diskette/CD-ROM drive

Note: Before beginning, read "Safety information" on page 109, "Before you begin"
To remove the diskette/CDROM drive:
78
Hardware Maintenance Manual: xSeries 342 Type 8669
on page 40 and "Handling static-sensitive devices" on page 41.
on page 40 and "Handling static-sensitive devices" on page 41.