IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual page 107

Error Code/Symptom
5962 (IDE CD-ROM configuration error)
8603 (Pointing Device Error)
00019501 (Processor 1 is not functioning -
check VRM and processor LEDs)
00019502 (Processor 2 is not functioning -
check VRM and processor LEDs)
00019701 (Processor 1 failed)
00019702 (Processor 2 failed)
00180100 (A PCI adapter has requested
memory resources that are not available.)
00180200 (No more I/O space available
for PCI adapter)
00180300 (No more memory (above 1MB
for PCI adapter))
00180400 (No more memory (below 1MB
for PCI adapter))
00180500 (PCI option ROM checksum
error)
00180600 (PCI to PCI bridge error)
FRU/Action
1. Run Configuration/Setup
2. CD-ROM Drive
3. CD-ROM Power Cable
4. IDE Cable
5. System Board
6. Battery
1. Pointing Device
2. System Board
1. VRM 1
2. Processor 1
3. System Board
1. VRM 2
2. Processor 2
1. Processor 1
2. System Board
1. Processor 2
2. System Board
1. Reorder the adapters in the PCI slots. It is important that your boot
device is positioned early in the scan order so that it is executed by
POST.
2. Ensure that the PCI adapter and all other adapters are set correctly
in the Configuration/Setup Utility program. If the memory resource
settings are not correct, change the settings.
3. If all memory resources are being used, you might need to remove
an adapter to make memory available to the PCI adapter. Disabling
the adapter BIOS on the adapter might correct the error. (Refer to
documentation provided with the adapter.)
1. Run Configuration/Setup
2. Failing Adapter
3. System Board
1. Run Configuration/Setup
2. Failing Adapter
3. System Board
1. Run Configuration/Setup
2. Move the failing adapter to slot 1 or 2
3. Failing Adapter
4. System Board
1. Remove Failing PCI Card
2. System Board
1. Run Configuration/Setup
2. Move the failing adapter to slot 1 or 2
3. Failing Adapter
4. System Board
97
Symptom-to-FRU index