Installing The Server Cover And Bezel - IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual

Attention: Replace a fan that has failed within 48 hours to help ensure proper
To replace a hot-swap fan assembly:
1. Remove the cover. See "Removing the cover and bezel" on page 42.
2. The LED on the failing fan assembly will be lit. Remove the failing fan assembly
3. Slide the replacement fan assembly into the server until it clicks into place.
4. Verify that the FAN LED on the diagnostics panel on the system board is not lit.
5. Replace the cover. See "Installing the server cover and bezel" below.

Installing the server cover and bezel

To install the server cover:
1. Place the cover-release latch in the open (up) position and align the flanges on
64
Hardware Maintenance Manual: xSeries 342 Type 8669
cooling.
Fan 2
Fan 1
Attention: To ensure proper system cooling, do not remove the top cover for
more than 30 minutes during this procedure.
from the server by lifting the orange handle on the top of the fan assembly and
and pulling the fan assembly away from the server.
If the FAN LED is lit, reseat the fan.
Side latch
the left and right sides of the cover with the slots on the server chassis.
Fan 3
Handle
Cover-release latch
Side latch
Bezel