Post Error Messages - IBM 6219 - IntelliStation M - Pro User Manual

POST error messages

The following table provides information about the POST error messages that can
appear during startup.
Table 3. POST error messages
POST message Description
062 The computer failed to start on three consecutive attempts.
All caches are disabled. Repeatedly turning the computer on and then off or resetting the
computer might cause this problem.
Action: Take the following steps to correct the problem:
1. Start the Configuration/Setup Utility program and verify that all settings are correct. Use the
2. Install a new battery. See "Replacing the battery" on page 85 for instructions.
If the problem remains, call for service. When the problem is corrected, be sure to enable the
caches.
101, 102, and 106 An error occurred during the system board and microprocessor test.
Action: Call for service.
114 An adapter read-only memory (ROM) error occurred.
Action: Remove the options. If you can start the computer without the options installed,
reinstall each option one at a time and retest after each is reinstalled. When an option fails,
replace it.
If you cannot isolate and correct the problem, call for service.
129 An error was detected in the L1 cache of one of the microprocessors.
Action: Take the following steps to correct the problem:
1. If you just installed a microprocessor, verify that the microprocessor is installed and seated
2. If the problem remains, call for service.
151 A real-time clock (RTC) error occurred.
Action: Call for service.
161 The real-time clock battery has failed.
Action: Replace the battery yourself or call for service.
You can use the computer until you replace the battery. However, you must run the
Configuration/Setup Utility program and set the time and date and other custom settings each
time you turn on the computer.
162 A change in device configuration occurred. This error occurs under one or more of the
following conditions:
v A new device has been installed.
v A device has been moved to a different location or cable connection.
v A device has been removed or disconnected from a cable.
v A device is failing and is no longer recognized by the computer as being installed.
v An external device is not turned on.
v An invalid checksum is detected in the battery-backed memory.
Action: Verify that all external devices are turned on. You must turn on external devices
before turning on the computer.
If you did not add, remove, or change the location of a device, a device is probably failing.
Running the Diagnostic program might isolate the failing device. See "Creating an IBM
Enhanced Diagnostics diskette" on page 82 and "Using the IBM Enhanced Diagnostics
diskette" on page 83.
If the problem remains, call for service.
Cache Control selection in the Advanced Setup menu of the Configuration/Setup Utility
program to enable the caches.
correctly.
Chapter 5. Solving problems
59