IBM 6219 - IntelliStation M - Pro User Manual page 60

10. If you have another adapter to install, repeat steps 4 through 9.
11. If you have installed a full-length adapter, rotate the front adapter-support
12. Reinstall the rear adapter-retention bracket; then, rotate the bracket to the
13. If you have other options to install, do so now; otherwise, continue with step
14. Replace the support bracket (see "Removing and installing the support
15. Replace the side cover (see "Replacing the side cover" on page 47).
16. Reconnect the external cables and power cords; then, turn on the attached
38
IBM IntelliStation M Pro Type 6219: User's Guide
Expansion
slot cover
Rear
adapter
retention
bracket
9. Connect required cables to the adapter. Route cables so that they do not block
the flow of air from the fans. If you are installing an optional SCSI adapter, see
"Cabling an optional SCSI adapter" on page 39 for additional information.
bracket to the closed (locked) position.
Note: If any adapter in your computer is large or has heavy cables attached to
it, you can secure the adapter with a screw: insert one backup
expansion-slot screw (stored next to slot 1) through the top of each
adapter bracket into the screw hole and secure the adapter before
proceeding to the next step.
closed (locked) position.
Note: The rear retention bracket rests against the computer side cover. You
might find it easier to lay the computer on its side to replace the side
cover.
14.
bracket" on page 35).
devices and the computer.
Adapter
Front
adapter
retention
bracket
94
13