IBM 6219 - IntelliStation M - Pro User Manual page 64

10. Route the signal cable so that it does not block the airflow to the rear of the
11. Connect the power cable to the back of the drive. The connectors are keyed
12. If you have other options to install or remove, do so now.
13. Replace the support bracket (see "Removing and installing the support
14. Replace the side cover (see "Replacing the side cover" on page 47).
15. Reconnect the external cables and power cords; then, turn on the attached
42
IBM IntelliStation M Pro Type 6219: User's Guide
6. Touch the static-protective package containing the drive to any unpainted metal
surface on the computer; then, remove the drive from the package and place it
on a static-protective surface.
7. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Note: You might find it easier to install the new drive into the appropriate
opening on the front, and then attach the cables.
8. If you are installing a 5.25-in. drive in bay 2, push the drive into the bay; then,
use the two screws to attach the drive to the drive cage. If you are installing a
3.5-in. drive in bay 2, you must attach the 5.25-in. conversion kit, supplied with
your option, to the 3.5-in. drive.
9. Determine whether the drive is an IDE or SCSI device; then, connect one end
of the appropriate signal cable into the back of the drive and the other end of
this cable into the appropriate IDE or SCSI connector on the system board.
See "Power and signal cables for internal drives" on page 44 for additional
information about cabling drives and "System-board internal connectors" on
page 32 for the location of IDE and SCSI connectors on the system board. If
there are open connectors on the cables connecting existing IDE or SCSI
drives, these cables can be used to connect the new drive.
drives or over the microprocessor.
and can be inserted only one way.
bracket" on page 35).
devices and the computer.
EMC shield
Filler panel
94
13