Table of Contents
Advertisement
v You might want to create update diskettes that contain the latest baseboard
Updating the server configuration
When you start the server for the first time after you add or remove an internal
option or external SCSI device, you might receive a message that the configuration
has changed. The Configuration/Setup Utility program starts automatically so that
you can save the new configuration settings. For more information, see the section
about configuring the server in the User's Guide on the IBM Eserver
Documentation CD.
Some options have device drivers that you must install. See the documentation that
comes with each option for information about installing device drivers.
The server comes with at least one microprocessor. If more than one
microprocessor is installed, the server can operate as an SMP server. You might
have to upgrade the operating system to support SMP. For more information, see
the section about using the ServerGuide Setup and Installation CD in the User's
Guide and the operating-system documentation.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about configuring disk arrays.
If you have installed a Remote Supervisor Adapter II to manage the server
remotely, see the Remote Supervisor Adapter II Installation Guide and the User's
Guide that comes with the adapter for information about setting up, configuring, and
using the adapter.
For information about configuring the integrated Gigabit Ethernet controllers, see
the User's Guide on the IBM Eserver Documentation CD.
28
eServer 326m Type 7969: Installation Guide
management controller firmware and BIOS code. Use an external USB diskette
drive if you want to attach a diskette drive to this server. For information about
updating the baseboard management controller firmware, see "Using the
baseboard management controller firmware update program" on page 37. For
information about updating the BIOS code, see the User's Guide on the IBM
Eserver Documentation CD.
Advertisement
Table of Contents
