To install a hot-swap SCSI hard disk drive, complete the following steps.
Drive bay 1
1. Read the safety information that begins on page v, and "Installation guidelines"
on page 9.
2. Remove the filler panel from the applicable drive bay.
Note: To ensure adequate system cooling, do not operate the server for more
than 2 minutes without either a hard disk drive or a filler panel installed in
each bay.
3. Install the new hard disk drive in the drive bay.
4. Check the hard disk drive status LED and activity LED to verify that the drive is
operating correctly.
5. If you have other options to install, install them now. Otherwise, go to
"Completing the installation" on page 26.
Drive bay 2
Filler panel
Hard disk drive
Drive tray
Drive tray handle
(in open position)
Chapter 2. Installing options
19