Table of Contents
Advertisement
Other 3D functions
SCOPE button/lamp
You can display the wave form monitor or vector scope, and compare and check the SDI IN 1/L and SDI IN 2/R input signals.
●
Works in MIX mode. The operation to be performed differs in other modes. (→ page 9)
●
Each time you press the SCOPE button, the display mode changes in the following order.
No display
Parallel wave form
monitor
Parallel vector scope
Difference wave form
monitor
Difference vector
scope
Y
Parallel wave form monitor
• When the CAMERA ASSIST MENU "LR SWAP" is set to "ON", L and R images of the parallel wave form monitor and vector scope are
exchanged and then displayed.
• The positions of the wave form monitor and vector scope can be changed in "POSITION" under the MAIN MENU "SCOPE SETTING."
• The wave form monitor and vector scope are not displayed in "R SHIFT" or "ANAGLYPH" of the CAMERA ASSIST MENU.
• The vector scope is not displayed when the input signals are RGB.
3D CURSOR button/lamp
When 3D is "ON", the L and R lines measuring the visual difference between L and R images, and the pixels and percentage between the
lines, are displayed. The following two modes are available for the line display: "Cursor mode" and "Grid mode."
●
Each time you press the 3D CURSOR button, the line display mode changes in the following order.
●
The information (→ page 10) and SCOPE are not displayed in "Cursor mode" or "Grid mode."
●
The positions of the pixels and percentage can be changed in "POSITION" under the MAIN MENU "INFORMATION."
Cursor mode
The L, R, and H lines appear, which measure the visual difference.
●
The H and L lines are fined dotted lines, and the R line a coarse dotted line. The selected line is displayed as a solid line.
L line (Group A)
●
The line color changes when the line goes beyond "FAR LIMIT" or "NEAR LIMIT" under the MAIN MENU "3D SETTING."
●
The ratio of the difference between the L and R lines to the horizontal pixels appears in the percentage display.
●
In the percentage display, "+" indicates the pop-up level (when the L line is placed on the right of the R line), and "–" the depth
(when the L line is placed on the left of the R line).
16
: Does not display the wave form monitor/vector scope.
: Tiles the wave form monitors of the images input into the SDI IN 1/L and SDI IN 2/R terminals.
: Tiles the vector scopes of the images input into the SDI IN 1/L and SDI IN 2/R terminals.
: Select this to display the differential of the signals from the SDI IN 1/L and SDI IN 2/R terminals in
wave form monitor.
:
Select this to display the differential of the signals from the SDI IN 1/L and SDI IN 2/R terminals in
vector scope.
Y
Parallel vector scope
No display
R line (Group A)
R line (Group B)
Y
Difference wave form monitor
Cursor mode
Grid mode
Pixels/Percentage between L and R lines
-
H line (Group B)
H line (Group A)
(selected line)
L line (Group B)
Difference vector scope
Advertisement
Table of Contents
