Rear Panel; Figure 3. Rear Panel Of The Cd-Rw Drive - Teac CD-W540E User Manual

Rear Panel

Figure 3 illustrates the rear panel of the CD-RW Drive.
analog audio
S1
connector
S1: Reserved for factory use only.
analog audio output connector: You can use an audio cable to connect this
connector to the audio input connector on a sound card. Pin assignments are
described in the following table:
Pin Number
1
2
3
4
CSEL/Slave/Master configuration jumper: The CD-RW drive includes
three pairs of jumper pins on the rear panel that allow you to set the drive to
CSEL, Slave, or Master mode. (For more information, see"Configuring the
CD-RW Drive" and Figure 5 on page 7.)
interface connector: Use the included IDE interface ribbon cable to connect
the CD-RW drive to an IDE interface in your computer. (For more
information, see "Installing the CD-RW Drive" on page 8 and Figure 7 on
page 9.)
power connector: Connect the power connector to the +5VDC and +12VDC
power sources. The +5VDC terminal is on the left as you face the rear panel;
the +12VDC terminal is on the right. The two center terminals are ground
terminals. (For more information, see "Installing the CD-RW Drive" on
page 8 and Figure 7 on page 9).
FG: Frame ground. This is a ground connection for the CD-RW drive.
TEAC CD-RW Drive User's Manual
CSEL/Slave/Master
configuration jumper

Figure 3. Rear Panel of the CD-RW Drive

Audio Signal
Left signal
Ground
Ground
Right signal
interface power
connector connector
Rear Panel
frame
ground
5