50°C Rear Expansion Slot Cover Vents; 50°C Front Bezel; 50°C Heat Sink - HP rp5800 Maintenance And Service Manual

50°C rear expansion slot cover vents
Using the computer in 50°C mode requires that you install two half-height and two full-height
expansion slot cover vents on the rear of the unit. To install these vent covers, follow the procedures
in Expansion Cards on page 54
illustrates the rear of the computer with vent covers installed.
Figure 7-72
50°C front bezel
Using the computer in 50°C mode requires that you install the correct front bezel that does not
include an optical drive. To install the bezel, see
illustrates the front of the computer with the 50°C bezel installed.
Figure 7-73
50°C heat sink
Using the computer in 50°C mode requires that you install a copper-based heat sink. Shape and
installation procedure is the same as the standard, aluminum-based heat sink. To install the heat
sink, see Heat sink on page
106 Chapter 7 Removal and Replacement Procedures
regarding removing and installing slot covers. The following image
Installing expansion slot cover vents
50°C bezel configuration
91. The following image illustrates the 50°C heat sink.
Front Bezel on page 43. The following image