50°C Radial Fan - HP rp5800 Maintenance And Service Manual

The following image illustrations a typical 50°C configuration.
Figure 7-61
50°C radial fan
The 50°C configuration requires a radial fan assembly is installed in the optical drive bay.
To replace the radial fan assembly:
1. Prepare the computer for disassembly
2. Remove the access panel
3. Raise the drive cage to its upright position.
4. Disconnect the fan cable from the system board connector labeled CHFAN2 (1).
5. Remove the fan cable from the clips built into the top of the heat partition (2).
50°C configuration
(Access Panel on page
(Preparation for Disassembly on page
42).
41).
50°C configuration components 99