Figure 7-20
To install a Powered Serial Port expansion card:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Rotate the power supply all the way back to access the full-height expansion card retention
latch.
NOTE:
from the rear of the computer so that the connectors do not block the power supply from rotating
all the way back.
Figure 7-21
64
Chapter 7 Removal and Replacement Procedures
Removing the Powered Serial Port Caps
(Access Panel on page
If you are using a PS/2 mouse and/or PS/2 keyboard, make sure they are unplugged
Raising the Power Supply
(Preparation for Disassembly on page
42).
41).