HP rp5800 Maintenance And Service Manual page 132

Table C-1 Numeric Codes and Text Messages (continued)
Control panel message
512-Chassis, Rear Chassis, or Front
Chassis Fan not Detected
514-CPU or Chassis Fan not Detected
610-External Storage Device Failure
611-Primary Floppy Port Address
Assignment Conflict
660-Display cache is detected unreliable
912-Computer Cover Has Been Removed
Since Last System Startup
917-Front Audio Not Connected
918-Front USB Not Connected
921-Device in PCI Express slot failed to
initialize
1151-Serial Port A Address Conflict
Detected
1152-Serial Port B Address Conflict
Detected
1155-Serial Port Address Conflict Detected
1201-System Audio Address Conflict
Detected
122 Appendix C POST Error Messages
Description
Chassis, rear chassis, or front chassis fan is
not connected or may have malfunctioned.
CPU or chassis fan is not connected or may
have malfunctioned.
External tape drive not connected.
Configuration error.
Integrated graphics controller display cache
is not working properly and will be disabled.
Computer cover was removed since last
system startup.
Front audio harness has been detached or
unseated from motherboard.
Front USB harness has been detached or
unseated from motherboard.
There is an incompatibility/problem with this
device and the system or PCI Express Link
could not be retrained to an x1.
Both external and internal serial ports are
assigned to COM1.
Both external and internal serial ports are
assigned to COM2.
Both external and internal serial ports are
assigned to same IRQ.
Device IRQ address conflicts with another
device.
Recommended action
1. Reseat chassis, rear chassis, or front
chassis fan.
2. Reseat fan cable.
3. Replace chassis, rear chassis, or front
chassis fan.
1. Reseat CPU or chassis fan.
2. Reseat fan cable.
3. Replace CPU or chassis fan.
Reinstall tape drive or press
system to reconfigure without the drive.
Run Computer Setup and check the
configuration in Advanced > Onboard
Devices.
Replace system board if minimal graphics
degrading is an issue.
No action required.
Reconnect or replace front audio harness.
Reconnect or replace front USB harness.
Try rebooting the system. If the error
reoccurs, the device may not work with this
system
1. Remove any serial port expansion
cards.
2. Clear CMOS.
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Remove any serial port expansion
cards.
2. Clear CMOS.
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1. Remove any serial port expansion
cards.
2. Clear CMOS.
3. Reconfigure card resources and/or run
Computer Setup or Windows utilities.
Enter Computer Setup and reset the IRQ in
Advanced > Onboard Devices.
F1 and allow