Switching A/B Speaker System - Pioneer Elite VSX-49TXi Operating Instructions Manual

Audio/video multi-channel receiver
Hide thumbs Also See for Elite VSX-49TXi:
Table of Contents

Advertisement

Switching A/B Speaker System

This unit has three types of speaker systems A, B, A&B. This switch allows you to select the speaker system
you will use.
Receiver
MAIN
BASS/
TONE
TREBLE
EFFECT/
DISPLAY
VIDEO
DIMMER
SELECT
SPEAKER
1
STATUS
LOUDNESS
A/B
SYSTEM
TAPE 2
SETUP
MONITOR
1
• Depending on the settings in "SPEAKER SYSTEMS" and the MULTI CH IN SELECT, output from the
memo
surround back pre out terminals may change.
• When using headphones the speakers are switched off.
• Please use speakers with a nominal impedance rated 6 -16 .
SUB
CH SEL.
INPUT
ATT.
SIGNAL
SELECT
A(SP3A):
B(SP3B):
A&B(SP3AB):
OFF(SP3 ):
Using Other Functions
1 Use the SPEAKER A/B button on the
remote control's SUB screen (or SP
SYSTEM A/B on the front panel) to
cycle through the different speaker
systems.
The button cycles through the speaker systems as
follows: A]B]A&B]off.
In what way the sound will be output depends on
the selections you made in "SPEAKER SYSTEMS"
(p.41) and you choices here. See the explanations
for a guide to how the sound will be output when
you have chosen NORMAL SURROUND (see p.41-
42).
Sound is output from speaker system A and the same
signal is output from the pre out terminals. (Subwoofer
output depends on the settings in SPEAKER SYSTEMS
and the source type.)
Sound is output from the two speakers in speaker
system B. Multichannel sources will be downmixed to
these two speakers and the same signal is output from
the FRONT pre outs.
Sound is output only from speaker system A's FRONT
speakers, a subwoofer and the B speakers. (Subwoofer
output depends on the settings in SPEAKER SYSTEMS
and the source type.) The main channels will be
downmixed to the FRONT speakers. If you have set
the FRONT speakers to "SMALL" the low frequencies
of all the channels are output from the subwoofer. The
same sound as FRONT speakers is output from the B
speakers and the FRONT pre out terminals.
No sound is output from the speakers. Depending on
the input signal and settings in "SPEAKER SYSTEMS"
sound may be output from the subwoofer. The same
sound is output from the pre out terminals as when
selecting speaker system A (above).
77

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents