Playing A Dvd With Surround Sound; Personalizing Your Sound - Pioneer Elite VSX-49TXi Operating Instructions Manual

Quick Start Guide Part2
memo
• Make sure the room environment follows the
guidelines displayed on the OSD during auto
setup. If the room environment is not optimal
for auto setup (too much ambient noise,
obstacles blocking the speakers from the
microphone, etc.) the final settings may be
incorrect. Check for household appliances (air
conditioner, fridge, fan, etc.) that may be
affecting the environment and switch them
off if necessary.
• Some older TVs may interfere with the
operation of the mic. If this is the case turn
the TV off when doing the auto setup.
• Screens will turn off after three minutes and
the receiver will automatically exit from the
setup process.
• If you leave CHECK!! or other error message
on the screen for three minutes, or you
choose CANCEL at anytime during the setup,
the settings made up to that point will be
cleared.
• After completing the Auto Surround Sound
Setup, ACOUSTIC CAL EQ ON (ALL CH ADJ)
is set automatically.

2 2 2 2 2 Playing a DVD with Surround Sound

1 Make sure the receiver, your TV, and your DVD player are switched ON.
2 Press the DVD/LD button on the remote control.
You should see "DVD/LD" in the display on the receiver.
3 Press the LISTENING CH SELECT button on the remote control
repeatedly until you
To locate the LISTENING CH SELECT button, press the RECEIVER button then press MAIN to access
the main remote control screen.
4 Press the STANDARD button on the remote control for the basic
surround sound setting.
If you don't see the STANDARD button, press the RECEIVER button then press MAIN to access the
main remote control screen.
5 Play a DVD then adjust the MASTER VOLUME.

3 3 3 3 3 Personalizing Your Sound

1 Use the Surround Listening Mode buttons to find the listening mode(s)
that work best for the source material.
For more information see pages 52–55.
To get a more refined sound, make the sound settings in "Expert
2
Setup" (p.97–103).
18
The system will output another series of test tones
to establish the proper channel level, channel delay
and acoustic calibration EQ. Again, be prepared for
loud test tones.
After it has finished, you see the SPEAKER
SYSTEMS CHECK screen. If you want to view the
settings select NEXT and press ENTER repeatedly.
If not, simply go to the next step.
13 Select RETURN to go back to the
SYSTEM SETUP menu, then choose
EXIT to complete the auto surround
sound setup and return to normal
use.
You should now have settings that will give you good
surround sound. The MCACC indicator will also light
up to show that the surround sound settings are
complete.
see "7.1" in the display on the receiver.