Pioneer Elite VSX-49TXi Operating Instructions Manual page 116

Techno Tidbits & Problem-solving
Problem
When playing a DTS format
LD there is noise audible on
the soundtrack.
Can't record audio.
Video
The Setup screen doesn't
appear.
Color noise appears on the
display screen.
No image is output when an
input is selected.
After connecting the TV and
selecting the proper video
input, there is still no image.
There is no image coming
from the selected component
video jacks.
Can't record video.
Input/display
The display is dark.
You can't change the device
input even when you press
the function key on the
remote.
You can't get DIGITAL or 2
RF to come up when using
the SIGNAL SELECT button.
The digital format indicator
doesn't light up even when
playing a non-PCM digital
source.
116
Cause
• The SIGNAL SELECT is on ANALOG.
• You are trying to make an analog
recording from a digital signal, or a digital
recording of an analog source.
• The digital source is copy protected.
• The REC jacks have not been connected
properly.
• See same problem on p.113.
• See same problem on p.113.
• Improper connections.
• The input source on the TV monitor is
not properly selected.
• The video input selected on the TV
monitor is incorrect.
• The COMPONENT VIDEO IN setting is
incorrect.
• The cord connect to the TV is composite
or S video.
• You are trying to record a source
connected to the component video jacks.
• The source is copy protected.
• The DISPLAY DIMMER button is pushed.
• DIRECT FUNCTION is set to OFF.
• Either the digital connections or the
DIGITAL IN setting is incorrect.
• Tape 2 MONITOR is on.
• MULTI CH IN mode is on.
• You're in an unassigned i.LINK function.
• The player is paused or stopped.
• There is a mistake in the player settings
for audio output.
Remedy
• Set the SIGNAL SELECT to DIGITAL
(p.51).
• You can only record analog to analog, or
digital to digital.
• You can't record digital sources that have
been copy protected.
• Check all connections.
• Make sure the component is connected
correctly (p.20-22).
• Select the correct function.
• Please read the TV monitor manual and
change the settings accordingly.
• Select the correct COMPONENT VIDEO
IN setting (p.94).
• Use a component video cord to connect
to the TV as well (see p.19).
• Connect the source component to either
the composite video, or the S video jacks
(p.19).
• You can't record sources that have been
copy protected.
• Press DISPLAY DIMMER on the remote
control repeatedly to return to the default
setting (p.62).
• Switch DIRECT FUNCTION to ON (p.74).
• Make sure the digital connections and
the DIGITAL IN setting (p.93, 95) is done
correctly.
• Press the Tape 2 MONITOR button so it
goes into the off setting (p.60).
• Turn MULTI CH IN mode off (p.59).
• Select the correct input function.
• Play the source.
• Fix the audio settings (check the manual
that came with your DVD player).