Color Burst On/Off For The Setup Screen - Pioneer Elite VSX-49TXi Operating Instructions Manual

COLOR BURST ON/OFF for the Setup Screen

Usually COLOR BURST default settings are OK but there are special cases where some TVs do not handle
COLOR BURST correctly. Some TVs connected to the Receiver with component video cords will not display the
Setup Screen when COLOR BURST is set to ON (default). If this happens, set COLOR BURST to OFF.
Also, some TVs connected to the Receiver with composite video cords will display color noise with the Setup
Screen when COLOR BURST is set to OFF. If this happens, reset COLOR BURST to ON.
1
STANDBY/ON
1
VIDEO SELECT
1 From the Standby mode, and while
holding down the VIDEO SELECT
button, press the STANDBY/ON
button.
Each time you do this COLOR BURST switches
between ON and OFF.
memo
COLOR BURST cannot be turned on or off when
MULTI-ROOM is set to ON. If you want to turn
COLOR BURST on or off, first turn MULTI-ROOM
off.
Basic Operation
63