Setting Up The Main Unit; Assigning The Digital Inputs - Pioneer Elite VSX-49TXi Operating Instructions Manual

3 3 3 3 3 Setting up the Main Unit

1 Connect the supplied AC power cord to the back of the main unit and plug the
other end into a wall outlet (don't use any other power cord than the one that
came with this receiver).
2 Press the
POWER
3 Press the STANDBY/ON button to switch the receiver ON.

4 4 4 4 4 Assigning the Digital Inputs

This is only necessary if you did not hook up your DVD player to DIGITAL IN 1 using a coaxial cable, as in
the first diagram on p.13, but rather connected it to one of the optical digital inputs. The following example
shows how to assign the DIGITAL IN 4 jack to DVD.
1
Receiver
RECEIVER
BASS/
TONE
ATREBLE
DVD/LD
VCR1
DISPLAY VIDEO
/DVR
DIMMER SELECT
VCR2
SPEAKER
STATUS
A/B
VCR3
SYSTEM
3
TV SETUP
4
System Setup
[ Auto Surround Setup ]
[1. Input Assign
[2. Surround Setup]
[3. Expert Setup]
[4. THX Audio Setup]
[Exit]
5
1.Input Assign
[ 1.Digital-In ]
[ 2.Component Video In ]
[ 3.i.LINK Input ]
[Return]
6
1.1. Digital-In
Digital-1 [ DVD/LD ]
Digital-2 [
Digital-3 [
Digital-4 [
Digital-5 [ VCR1 ]
Digital-6 [ VCR2 ]
Digital-7 [ CD-R ]
RF IN [ DVD/LD ]
[Return]
7
1.1. Digital-In
Digital-1 [
Digital-2 [
Digital-3 [
Digital-4 [ DVD/LD
Digital-5 [ VCR1 ]
Digital-6 [ VCR2 ]
Digital-7 [ CD-R ]
RF IN [ DVD/LD ]
[Return]
ON/OFF button to put the receiver in ON mode.
2
MAIN SUB REMOTE
SETUP
CD
CD-R/
TAPE1
EFFECT/
CH SEL.
TUNER
VIDEO
INPUT
LOUDNESS
ATT.
SAT
TAPE 2 SIGNAL
TV
MONITOR SELECT
CONTROL
]
TV ]
CD ]
SAT ]
OFF ]
TV ]
CD ]
]
Quick Start Guide Part1
1 Turn on the receiver and your TV,
press RECEIVER on the remote
control.
2 Press the SUB button on the
RECEIVER remote control screen.
3 Press the SYSTEM SETUP button.
The SYSTEM SETUP menu appears on your TV (if it
doesn't, refer to page 13 to make sure you have
properly connected the receiver to your TV).
4 Looking at the on-screen display on
your TV, use the 5∞ buttons to
select INPUT ASSIGN. Press the
ENTER button.
5 DIGITAL IN should be selected, if not
use the 5∞ buttons to select it.
Press the ENTER button.
6 The default setting for the DIGITAL-4
jack is SAT.
7 Use the 2 3 buttons to select DVD/
LD.
8 Select RETURN with the 5∞ buttons
and press ENTER.
You will return to the SYSTEM SETUP menu.
9 Choose EXIT with the 5∞ buttons
and press ENTER.
The receiver exits the setup process.
15