Setting A Source For The Clone Switch - Symantec GHOST IMAGING FOUNDATION 7.1 - V1.0 Manual

Setting a source for the clone switch

The syntax for this switch is as follows:
SRC={disk | file | multicast | tape | cd writer }
SRC defines the source for the operation that is selected by the clone mode option.
Table B-6 lists the source switches.
Source options for cloning
Table B-6
Switch Source
disk drive number
file filename
multicast @mcsessionname
tape @MTx
Explanation
Source disk drive number. Numbers start at 1.
For example:
SRC=1
A partition on a drive can also be specified.
Numbers start at 1. For example:
SRC=1:2
The source image file name. For example:
SRC= g:\source.gho
A partition in an image file can also be specified.
For example:
SRC=g:\source.gho:2
Files can also be read from a CD-ROM drive.
The following files types are supported: .gho,
.vmdk, .pqi, .v2i, .iv2i.
Note: .pqi, .v2i, and .iv2i are only available in
Ghost32 with the v2idisklib.dll present.
The name of the multicast session.
The tape drive number. Numbers start at 0. For
example:
SRC=@MT0
A partition on a tape can also be specified. For
example:
SRC=@MT0:3
Command-line switches
Using the clone switch
151