Symantec GHOST IMAGING FOUNDATION 7.1 - V1.0 Manual page 146

146 Command-line switches
Command-line switches
-split=x
-sure
-sze
-szee
-szef
-szel
Splits image file into x MB spans. Use this switch to create a forced-size volume set. For
example, if you want to force smaller image files from a 1024-MB drive, you could specify
200-MB segments.
For example:
ghost.exe -split=200
This divides the image into 200-MB segments.
If this switch is not used then an image is split at 2 GB in the following operations:
GhostCast
Peer-to-peer
Creating an image on a mapped-network drive
If the operation runs locally on a FAT partition, then the image splits at 4 GB.
If this switch is explicitly set to 0, the image does not split.
Use the -sure switch in conjunction with -clone to avoid being prompted with the final
question "Proceed with disk clone - destination drive will be overwritten?" This command
is useful in batch mode.
Sets the size for the destination partitions for either a disk restore or disk copy operation.
When numbering partitions in the -sze switch, do not include the hidden Ghost partition.
This switch is intended to be used in the Additional command line in the Console. All
functionality of -sze switches are supported.
See "Setting a destination size for the clone switch"
Forces Symantec Ghost to keep the sizes of all destination partitions the same size as in
the source partition (no resizing).
This switch can be used with or without the -clone switch.
See "Setting a destination size for the clone switch"
Forces Symantec Ghost to keep the sizes of all destination partitions, except for the first
one, the same size as in the source partition. The first partition uses the remaining disk
space.
This switch can be used with or without the -clone switch.
See "Setting a destination size for the clone switch"
Forces Symantec Ghost to keep the sizes of all destination partitions, except for the last
one, the same size as in the source partition. The last partition uses the remaining disk
space.
This switch can be used with or without the -clone switch.
See "Setting a destination size for the clone switch"
on page 154.
on page 154.
on page 154.
on page 154.