Defining The Type Of Clone Command - Symantec GHOST IMAGING FOUNDATION 7.1 - V1.0 Manual

Defining the type of clone command

The syntax for the clone switch is:
-clone,MODE={operation},SRC={source},DST={destination},
[SZE{size},SZE{size}.......]
MODE defines the type of clone command.
The syntax is as follows:
MODE={copy | restore | create | pcopy | prestore | pcreate}
Table B-4 lists the mode commands.
Mode commands
Table B-4
Switch
copy
restore
Note:
The load switch is replaced by the restore switch.
The load switch is still fully functional and is
interchangeable with restore.
create
Note:
The dump switch is replaced by the create switch.
The dump switch is still fully functional and is
interchangeable with create.
pcopy
prestore
Note:
The pload switch is replaced by the prestore
switch. The pload switch is still fully functional and is
interchangeable with prestore.
pcreate
Note:
The pdump switch is replaced by the pcreate
switch. The pdump switch is still fully functional and
is interchangeable with pcreate.
Cloning combination options
Table B-5 illustrates the possible cloning operations that you can perform.
Command-line switches
Using the clone switch
Action
Disk-to-disk copy
File-to-disk restore
Disk-to-file backup
Partition-to-partition copy
File-to-partition restore
Partition-to-file backup (allows
multipartition Ghost backup
selection)
149