Symantec ALTIRIS OUT OF BAND MANAGEMENT COMPONENT 7.0 SP3 - V1.0 Manual page 57

Options on the Update ASF Configuration Settings task page
Table 2-25
(continued)
Option
Modify timers settings
Enable OS hang watchdog
Enable ping to management
console
Modify spanning tree settings
Pingdestinationonlinkreconnect
Delay sending Platform Event
Traps on link reconnect
Modify remote control settings
ASF Reset
ASF Power down
ASF Power up
ASF Power cycle
Modify Broadcom ASF adapter
settings
About Out of Band Management Component pages
Update ASF Configuration Settings task
Description
Check to modify the settings in this group when the
task runs.
Check to watch for operating system hangs and type
the watch interval in seconds. Default: 30 seconds.
If you want the network adapter to ping the
management console, check this option and type the
ping interval in seconds. If the ping fails, the agent
goes into safe mode. Default: 30 seconds.
Check to modify the settings in this group when the
task runs.
Check this option if you want the network adapter to
ping the management console after the link is
temporarily lost and then restored. Type the interval
in seconds and the count of pings. Default: 10 seconds,
3 times.
Check this option if you want to delay sending events
to the management console after the link is restored:
for example, if the network traffic is high. Type the
number of seconds to wait. Default: 10 seconds.
Check to modify the settings in this group when the
task runs.
Check to enable a low latency reset of the system.
Check to enable unconditional power-down (occurs
without any blocking from software or system).
Check to ensure that the sleeping system can be
remotely turned on.
Check to enable a hard reset of the system. This reset
is functionally equivalent to an unconditional
power-down operation, followed by a power-up.
Check to modify the settings in this group when the
task runs.
The settings in this group are applied to the computers
with Broadcom ASF only.
57