Cisco WVC200 - Wireless-G PTZ Internet Camera Administration Manual page 92

Sample Configurations for the Cisco WVC210 Internet Camera
Configuring Port Forwarding
STEP 5
STEP 6
STEP 7
STEP 8
WVC210 Wireless-G PTZ Internet Video Camera With 2-Way Audio Administration Guide
From the web-based configuration utility, click Firewall > Port Range Forwarding.
This example shows the Port Range Forwarding window of the Cisco
WRVS4400N router.
In the Port Range Forwarding window, configure the following:
a. Enter the Application name, such as Camera.
b. Enter the Start and End port. In this example, 1028 is used and this should
match the HTTP port configured on the camera in
c. Ensure that Protocol is set to Both (TCP and UDP).
d. Enter the IP address of the camera, in the IP Address field.
e. Check the Enable box to enable forwarding.
Click Save to save the configuration to the router.
Locate the WAN IP address for your router. Click Setup > Summary to view the
WAN IP address of the router. The WAN IP address is displayed in the Network
Status Setting section.
Step 2 on page 85.
9
86