Network Settings - Cisco WVC200 - Wireless-G PTZ Internet Camera Administration Manual

Configuring the Cisco WVC210 Internet Camera Software
Setup > Basic Settings
NOTE
WVC210 Wireless-G PTZ Internet Video Camera With 2-Way Audio Administration Guide
• Check here if you want to update the time automatically through the NTP
Server on the Internet—Enable or disable the time server feature as
required. If enabled, the camera will contact a network time server at
regular intervals and update its internal timer.
• NTP Server Address—Enter the address of the NTP Server.
If connecting to a router, it may be necessary to enable port forwarding. See
"Configuring Port Forwarding" on page

Network Settings

Configuration Type
• Obtain An IP Address Automatically—The camera defaults to this option,
allowing a DHCP server on your network to automatically assign the camera
an IP address.
• Fixed IP Address—Use this option to assign a fixed (static) IP address to the
camera. Assign an IP address that is unique to your local network. When
using a fixed IP address, you must configure the IP Address, Subnet Mask,
Gateway, and DNS.
• IP Address—The IP address assigned to the camera.
• Subnet Mask—The Subnet Mask assigned to the camera.
• Gateway—IP address of the gateway router between this device and
management stations that exist on other network segments.
• Primary DNS—The IP address of your ISP's primary server, which translates
the names of websites into IP addresses.
• Secondary DNS—The IP address of your ISP's secondary server, which
translates the names of websites into IP addresses.
85.
8
47