LAN Settings
These settings are both for wired and wireless networks, used to configure
the WMA100 to match the wired LAN settings of your router or gateway. To
access the LAN Settings screen, select Setup from the Home screen,
select Advanced, select LAN, then press OK.
Auto Mode
The default screen you will see is for Auto mode, which automatically sets
the IP protocol to Dynamic IP (DHCP). In this mode no fields can be
changed. If you want to change any of the fields, select Switch to Manual
on the bottom of the screen.
LAN Settings Screen (auto mode)
Manual Mode
Manual Mode lets you enter the IP address, Sub Mask etc. according to
the requirements of your router or gateway. To return to Auto Mode, select
Automatic (DHCP) on the bottom of the screen.
NOTE: Use the Manual Mode for settings Static IP configuration.
LAN Settings Screen (manual mode)
ViewSonic Wireless Media Adapter
32