Step 6: Adjusting the Screen Image
•
If you used the WMA100's Composite Video or S-Video port to connect
to your display, no adjustment is necessary.
•
If you used the WMA100's Component or DVI/VGA port(s) to connect
to your display, adjustments may be necessary if you see symptoms (a)
or (b) below.
(a) There is no screen image or the screen image does not look clear.
After you turn on the WMA100, press the Output button on the Remote
Control. Wait two (2) seconds and if the image is still not clear, press the
Output button again. If the screen image is still not clear, press Output a
third time. The Output button has a total of three (3) settings.
(b) The screen image is shifted to the left or right.
(For DVI or VGA only) Select your displays's Auto adjustment control,
which automatically optimizes the size and position of the screen image.
See your display's user manual for further instructions.
Optimizing the WMA100's Screen Image
To optimize the screen image, do the following.
(for Component Video or DVI/VGA only)
1 Select Setup from the Home page, then select System from the Setup
menu.
2 Use the Up/Down Arrow buttons on the Remote Control to select an
image setting from the table to the right, then press OK.
NOTE: For the best screen image, select your display's Preferred Resolution
(see your display's user manual)..
ViewSonic Wireless Media Adapter
Composite
(CVBS) Video
DVI/VGA
Component
S-Video
Video
Image Setting Screen
Image Settings
Image Settings for
(resolutions) for
Component Video
DVI / VGA
(YPbPr)
640 x 480
480p
800 x 600
720p
1024 x 768
1080i
1280 x 720
1280 x 768
1280 x 1024
S-Video/Composite
852 x 480
NTSC
(Composite = CVBS)
1366 x 768
18