Step 5: Configure Your Wma100 - ViewSonic WMA100 - Wireless Media Adapter User Manual

Step 5: Configure Your WMA100

Dynamic or Static IP?
The instructions that follow below assume your network is set to use
Dynamic IP (DHCP). If your network is set to use Static IP, see Chapter 4:
Using Setup to Change Settings > LAN Settings > Manual Mode.
Wired Configuration
If your WMA100 is connected to your network using an Ethernet cable, no
configuration is necessary. This assumes you are using DHCP protocol.
Wireless Configuration with Auto-Sync
Auto-Sync makes wireless configuration easy by automatically detecting
the settings of your router or gateway. And if you added a WEP or WPA
key to your router or gateway, you can easily add that key to your
WMA100.
To configure your WMA100, do the following:
1 With your TV and WMA100 powered ON (LED will light blue), press the
Home button on the Remote Control. The Home Screen of the myView
Media Guide menu will display.
NOTE: myView Media Guide does not require installation because the
software is pre-installed inside the WMA100.
2 Press the Left Arrow button on the Remote Control to highlight the
Setup button on Home screen myView Media Guide, then press OK.
The Setup main menu will display. (See the illustration on the next
page.)
ViewSonic Wireless Media Adapter 16