Dixon ZTR 3000 Series Operator's Manual page 30

CARE AND MAINTENANCE - 3000 SERIES MODELS
CHANGING THE ENGINE OIL: MODELS ZTR 3303 - ZTR 3304 - ZTR 3014
1. The "snap lock" oil drain valve is located on the left side of the engine crankcase.
2. Place a suitable container under the drain valve. The fitting of a short piece of
hose to the valve will help direct the oil.
3. Push the valve body in and twist to clear the detent notch.
4. Pulling the valve body outward will start the flow of oil.
NOTE:
OIL FILL:
1. Push the valve body in and twist into the detent notch.
2. Clean any spilled oil from engine and chassis.
3. Refill engine with type, and quantity of oil recommended by the engine
manufacturer in engine literature.
PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS.
HOT oil may cause burns.
Allow engine to cool before draining oil.
Refer to engine manufacturers recommendations for frequency of oil
changes.
PROTECT YOUR ENVIRONMENT
Page 27