Dixon ZTR 3000 Series Operator's Manual page 11

CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
CAPACITIES:
DIMENSIONS:
NOTE:
Page 8
SPECIFICATIONS
Model ZTR 3303
The monocoque design chassis of the 3000 Series Models incorporates CMC
Laser and CNC brake processes to form the twin 12 gauge side frames and 7
gauge transmission and engine base plate.
All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
1 1 GA stamped steel construction. Single 30" cut blade.
Cut height approximately 1 " to 4" via 7 position lift handle.
Mechanical; hand lever engagement.
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
10.5 HP I/C Briggs & Stratton, 4-Cycle, Single Cylinder, Air-Cooled, Gasoline,
Vertical Shaft, Aluminum Head and Block.
Electric by key switch operation with safety interlocks on parking brake and blade
drive.
Front 11 X 4.00-5 ribbed tread. Rear
1 6 X 6.50 X 8 Turf Trac R/S Tread.
Fuel 2.0 gallons total.
Engine 1 .25 quarts oil.
Width 32.5" outside rear wheel measurement.
Height 32.0" to top edge of seat. Length
65.5" hitch tab to front bumper. Weight
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
430 Ibs.