Dixon ZTR 3000 Series Operator's Manual page 13

CHASSIS:
BODY:
MOWER DECKS:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
CAPACITIES:
DIMENSIONS:
NOTE:
Page 10
SPECIFICATIONS
Model ZTR 3014
The monocoque design chassis of the 3000 Series Models incorporates CMC
Laser and CMC brake processes to form the twin 1 2 gauge side frames and 7
gauge transmission and engine base plate.
All body parts are made of rotational molded polyethylene. Front body contains
access panel for battery service. Seat tilts forward to allow transmission service.
36" Deck: 1 1 GA Laser Cut Fabricated - 36" Cut Width 42"
Deck: 1 3 GA Stamped Steel Construction - 42" Cut Width
Cut height approximately 1" to 4" via 7 position lift handle.
Electric clutch.
Each rear wheel is independently driven by chain and sprockets through a
friction mechanical drive.
14 HP Briggs & Stratton OHV I/C Quiet, 4-Cycle, Single Cylinder, Air-Cooled,
Gasoline, Vertical Shaft, Cast Iron Cylinder, Synchro-Balanced, Laminated
Shroud.
Electric by key switch operation with safety interlocks on parking brake and blade
drive.
Front 11 X 4.00 -5 ribbed tread. Rear
1 8 X 8.50 X 8 Multi Trac tread.
Fuel 2.0 gallons total.
Engine 1 .25 quarts oil.
Width 43.0" outside rear wheel measurement. Height
36.0" to top edge of seat. Length
bumper. Weight 36" Deck: 500 Ibs.
520 Ibs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
65.5" hitch tab to front
42" Deck: