Cutter Blade Maintenance - Dixon SPEEDZTR 30 Safety & Operation Manual

CARE AND MAINTENANCE

CUTTER BLADE MAINTENANCE:

CAUTION Stop engine and remove ignition key
Check sharpness of mower blades after every 10
hours of operation. Observe proper blade position
prior to removal.
1. Safely raise front of mower.
2. Hold or block blade from
turning.
3. Loosen blade bolt and remove
blade.
4. When replacing blade, tighten
blade bolt securely. Refer to
diagram. Be sure blade is
centered on pilot before
tightening nut to 60 ft. lbs.
Blades should be discarded when worn excessively.
New Blade
for safety. Wear heavy, thick gloves
when holding onto cutter blade, avoid
the sharp edge of the blade.
When notch starts,
discard blade
33
DANGEROUS!
DO NOT USE
BLADE IN THIS
CONDITION!