Table of Contents
Advertisement
BASIC CONCEPT OF ADJUSTMENT /
Pitch to Elevator Mixing
Through the previous step, we've got rid of
the pitch to aileron mixing. It is as important
to vanish the pitch to elevator mixing. Place
the collective stick to the full positive pitch
position. Check the swashplate from a side
of the model to insure if it's level from head
to rear. If the swashplate is not level, adjust
the elevator servo by using the "Travel
Adjustment" function.
For example, the swashplate has been tilted
forward while giving full positive collective
pitch. It indicates that the elevator servo's
travel is less than the rest two's travel.
Please increase the travel of elevator servo.
Check the swashplate again to insure that
it's level.
It is necessary to repeat the procedure while
giving full negative collective pitch. Check if
the swashplate is level and adjust the elevator servo as needed while the full negative collective pitch is given.
升降舵與螺距混控修正
完成上一步驟後，接下來校正升降舵螺距。將發射機螺距撥桿置於最高側，從機體側面觀察十字盤是否前、後呈現水平
（如下圖）。若十字盤未呈現水平狀態，須使用行程設定功能（Travel Adjustment）調整升降舵控制伺服機。假設十
字盤向前傾斜（如圖示），表示升降舵伺服機行程量小於另外兩顆伺服機，需增加升降舵伺服機行程量，使十字盤達到
水平。將螺距撥桿置於最低側，重複以上步驟以確保十字盤水平。
SETTING UP OF LINKAGE /
The lengths of the linkage rods are recommended as the following:
連桿設定建議長度，請參照下列圖示
The pushrod length above is suitable for beginner and 3D flying. You can use those lengths as the starting
setting, and adjust the lengths for your flying style. The lengths of the pushrods are measured from the
center of the linkage ball to the center of another.
圖示連桿長度適用於初學者與3D進階飛行。您可在初步設定時依照圖示數據，後續再依照自己的飛行風格改變設定。
連桿長度以兩端球頭中心點距離長度為標準。
Increase
增加
（Right View / 右側圖）
18mm
25mm
41.5mm
20mm
36.5mm
-35-
The length is measured by
the center of the 2 ball links.
以兩端球頭中心點距離長度為連
桿長度
Hide quick links:
Advertisement
Table of Contents
