THUNDER TIGER MINI TITAN V2 - MANUAL 2 Instruction Manual page 23

Tail Boom Bracket Set-2 /
Bag M
No. Material No. Description
1 HNX2-10B SOCKET BUTTON HEAD SELF TAPPING SCREW, M2×10
2 HSA2-6 BUTTON HEAD SOCKET SCREW, M2X6
HNX2-10B
SOCKET BUTTON HEAD SELF TAPPING SCREW, M2×10
半圓頭內六角自攻螺絲 M2×10
HSA2-6
BUTTON HEAD SOCKET SCREW, M2X6
M2X6
半圓頭內六角螺絲
Note / 注意
Ensure the leading edge of the blades
rotate this way as drawing. (Turn the Main
Gear clockwise, the main rotor grips turns
clockwise and the Tail Blades turn counter
clockwise.)
請注意旋翼轉動方向應與圖示相同。
（順時針方向撥動主齒盤時，主旋翼頭夾座順
時針、尾旋翼逆時針轉動。）
Step 2 / 步驟二
1. Pull the Tail Boom out
slightly by grasping the Tail
Unit with one hand and the
main frame set with the
other. Adjust until the belt
deflects by about 0.2mm
(0.08").
2. Tighten the 4 lower Tapping
Screws（HSA2-6B,#2）to fix
the Tail Bracket on the main
frame set.
1. 一手固定主側板組，另一手握住
尾部將尾管向外拉，使皮帶拉緊
。適當的皮帶緊度應於推壓皮帶
時陷下少於0.2mm(0.08")。
2. 將下方的兩側4 顆螺絲螺緊，將
尾管固定座固定於主側板組。
名稱
半圓頭內六角自攻螺絲 M2×10
M2X6
半圓頭內六角螺絲
Step 1 / 步驟一
1. Remove the tap from the end of the belt. Insert the tail unit into the main frame set,
twist the belt toward right for 90° and then warp around the pulley.
2. First tighten the 4 upper Tapping Screws（HNN2-10B,#1）to attach the Tail Bracket on
the main frame set.
1. 移除皮帶末端膠帶。將尾部套入主側板組中，同時將皮帶向右扭轉90度後，繞過皮帶輪。
2. 先緊鎖上方的兩側4顆螺絲，將尾管固定座固定在主側板組上。
Tail / 機尾
Tail pulley
皮帶輪
(1)
Qty
4
4
(2)
(2)
-22-
-2
90°
Drive Gear Set
尾驅動輪組
(1)
Nose / 機頭