THUNDER TIGER MINI TITAN V2 - MANUAL 2 Instruction Manual page 21

Tail Unit Assembly-4 /
Bag L
No. Material No. Description
1 HME3-3B SET SCREW M3×3
2 HNU2-9Z SHOULDERED SCREW M2×9
HME3-3B
SET SCREW M3×3
M3×3
無頭內六角螺絲
HNU2-9Z
SHOULDERED SCREW M2×9
M2×9
圓頭十字軸套螺絲
(2)
T22
HSA2-6
BUTTON HEAD SOCKET SCREW, M2X6
半圓頭內六角螺絲
HMM2Z
LUCK NUT, M2
止鬆螺帽
Step 3 / 步驟三
Attach the Carbon Tail Fin to the Tail Unit as shown.
將碳纖垂直安定翼固定於尾管座。
名稱
M3×3
無頭內六角螺絲
M2×9
圓頭十字軸套螺絲
Step 1 / 步驟一
1. Slide the tail rotor set into the Tail Rotor Shaft.
Line the hole up with the concave on the shaft.
2. Secure the tail rotor set tightly by the Set
Screw with a drop of threadlocking.
1. 將組裝完成的尾舵控制臂與夾片組安裝至尾橫軸。
2. 無頭內六角螺絲需準確安裝於尾橫軸固定孔位，並
使用防鬆膠。
T22
(2)
(5)
-4
Qty No. Material No. Description
1 3 BK1501 3D CARBON TAIL FIN
4 HSA2-6 BUTTON HEAD SOCKET SCREW, M2X6
2
5 HMM2Z LUCK NUT, M2
Note / 注意
Line up the concave of tail rotor
shaft and the hole of hub.
尾橫軸上凹槽對正轉座上螺絲孔。
Step 2 / 步驟二
Fit the Tail Pitch Control Links to the Tail Pitch Control
Set. Do not over tighten the Socket Screw and ensure
the tail linkages run effortlessly.
將控制連桿與控制臂連接，請使用適量螺絲防鬆劑，勿過度鎖
緊固定螺絲，並確認機構可以靈活作動。
-20-
名稱
3D
碳纖維垂直安定面
半圓頭內六角螺絲
止鬆螺帽
T22
(1)
Completed View
組裝完成
(4)
Qty
1
2
2