Updating The Server Configuration - IBM 79788BU User Manual

There are release levers on the Ethernet and systems management connectors. To
disconnect a cable from one of these connectors, pull up on the lever to release the
cable.
Ethernet activity LED

Updating the server configuration

When you start the server for the first time after you add or remove an internal
option or external device, you might receive a message that the configuration has
changed. The Configuration/Setup Utility program starts automatically so that you
can save the new configuration settings.
Some options have device drivers that you must install. For information about
installing device drivers, see the documentation that comes with each option.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
If you have installed a Remote Supervisor Adapter ll SlimLine to manage the server
remotely, see the Remote Supervisor Adapter ll SlimLine User's Guide, which
comes with the adapter, for information about setting up, configuring, and using the
adapter.
For information about configuring the integrated Gigabit Ethernet controller, see
"Configuring the Gigabit Ethernet controller" on page 70.
USB cable
release lever
USB cable
Ethernet port
Ethernet speed LED
Ethernet cable
release lever
Chapter 2. Installing options
47