Table of Contents
Advertisement
The ServerGuide program performs the following tasks:
v Sets system date and time
v Detects the RAID adapter or controller and runs the SAS RAID configuration
v Checks the microcode (firmware) levels of a ServeRAID adapter and determines
v Detects installed hardware options and provides updated device drivers for most
v Provides diskette-free installation for supported Windows operating systems
v Includes an online readme file with links to tips for your hardware and
Setup and configuration overview
When you use the ServerGuide Setup and Installation CD, you do not need setup
diskettes. You can use the CD to configure any supported IBM server model. The
setup program provides a list of tasks that are required to set up your server model.
On a server with a ServeRAID adapter or SAS/SATA controller with RAID
capabilities, you can run the SAS RAID configuration program to create logical
drives.
Note: Features and functions can vary slightly with different versions of the
When you start the ServerGuide Setup and Installation CD, the program prompts
you to complete the following tasks:
v Select your language.
v Select your keyboard layout and country.
v View the overview to learn about ServerGuide features.
v View the readme file to review installation tips for your operating system and
v Start the operating-system installation. You will need your operating-system CD.
Typical operating-system installation
The ServerGuide program can reduce the time it takes to install an operating
system. It provides the device drivers that are required for your hardware and for
the operating system that you are installing. This section describes a typical
ServerGuide operating-system installation.
Note: Features and functions can vary slightly with different versions of the
1. After you have completed the setup process, the operating-system installation
2. The ServerGuide program stores information about the server model, service
3. The ServerGuide program presents operating-system partition options that are
4. The ServerGuide program prompts you to insert your operating-system CD and
program
whether a later level is available from the CD
adapters and devices
operating-system installation
ServerGuide program.
adapter.
ServerGuide program.
program starts. (You will need your operating-system CD to complete the
installation.)
processor, hard disk drive controllers, and network adapters. Then, the program
checks the CD for newer device drivers. This information is stored and then
passed to the operating-system installation program.
based on your operating-system selection and the installed hard disk drives.
restart the server. At this point, the installation program for the operating system
takes control to complete the installation.
Chapter 3. Configuring the server
57
Advertisement
Table of Contents
