Table of Contents
Advertisement
System-board option connectors
The following illustration shows the connectors on the system board for
user-installable options.
Microprocessor 2
connector
Fan 1 connector
Installation guidelines
Before you install options, read the following information:
v Read the safety information that begins on page v and the guidelines in
v Observe good housekeeping in the area where you are working. Place removed
v If you must start the server while the server cover is removed, make sure that no
v Do not attempt to lift an object that you think is too heavy for you. If you have to
v Make sure that you have an adequate number of properly grounded electrical
Remote Supervisor
Adapter II SlimLine
connector (J60)
"Handling static-sensitive devices" on page 25. This information will help you
work safely.
covers and other parts in a safe place.
one is near the server and that no tools or other objects have been left inside the
server.
lift a heavy object, observe the following precautions:
– Make sure that you can stand safely without slipping.
– Distribute the weight of the object equally between your feet.
– Use a slow lifting force. Never move suddenly or twist when you lift a heavy
object.
– To avoid straining the muscles in your back, lift by standing or by pushing up
with your leg muscles.
outlets for the server, monitor, and other devices.
PCI Express or
PCI-X riser-card
connector slot 2
(J12)
PCI-Express
riser card connector slot 1
(J34)
RAID controller
connector (J3)
(some models)
DIMM 5 connector
DIMM 6 connector
DIMM 7 connector
DIMM 8 connector
DIMM 1 connector
DIMM 2 connector
DIMM 3 connector
DIMM 4 connector
Chapter 2. Installing options
23
Advertisement
Table of Contents
