IBM 79788BU User Manual page 67

- BMC POST Watchdog Timeout
Set the BMC POST watchdog timeout value. 5 minutes is the default
setting.
- System-BMC Serial Port Sharing
Enable or disable sharing the serial port between the BMC and the system.
Disabled is the default setting; it assigns the serial port to the BMC
exclusively.
- BMC Serial Port Access Mode
If serial-port sharing is enabled, specify the times and conditions during
which the BMC shares the serial port.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Disabled is the default.
- BMC Network Configuration
View the BMC MAC address and the current BMC IP address. Define the
static BMC IP address, subnet mask, and gateway address, and specify
whether to use the static IP address or have DHCP assign the BMC IP
address.
- BMC System Event Log
Select this choice to view the BMC system event log, which contains
messages about system events, such as devices that have been installed
or removed or a threshold that has been reached. Select Clear BMC SEL
to clear the BMC system event log.
- User Account Settings
Define user names and passwords for logging in to the BMC to remotely
control settings in the server, such as power settings.
v Event/Error Logs
Select this choice to view and clear the POST error log and the system
event/error log.
– Post Error Log
Select this choice to view the three most recent error codes and messages
that were generated during POST. Select Clear POST Error Log to clear the
POST error log.
– System Event/Error Log
This choice is available only if an optional Remote Supervisor Adapter II
SlimLine is installed. Select this choice to view the error messages in the
system event/error log. You can use the arrow keys to move between pages
in the error log. Select Clear System Event/Error Log to clear the system
event/error log.
The system event/error log contains all event and error messages that have
been generated during POST, by the system management interface handler,
and by the system service processor. Run the diagnostic programs to get
more information about error codes that occur. See the Problem
Determination and Service Guide on the IBM Documentation CD for
instructions for running the diagnostic programs.
v Save Settings
Select this choice to save the changes that you have made in the settings.
v Restore Settings
Select this choice to cancel the changes that you have made in the settings and
restore the previous settings.
v Load Default Settings
Chapter 3. Configuring the server
53