Integrated Management Display
To remove the Integrated Management Display (IMD):
1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter.
2. Remove the top access panel. See "Top Access Panel" earlier in this chapter.
3. Disconnect the IMD cable from the I/O board.
4. Press in on the four locking tabs on the rear of the IMD
5. Pull the IMD from the front of the server
1
2
Figure 2-53. Removing the IMD
Reverse steps 1 through 5 to replace the IMD.
1
1
1
Removal and Replacement Procedures 2-59
.
.