Compaq ProLiant 8000 Maintenance And Service Manual page 155

6-28 Compaq ProLiant 8000 Servers Maintenance and Service Guide
Table 6-2
POST Error Messages
Error Code
1786-Slot 1 Drive
Array Recovery
Needed. The
following SCSI
drive(s) need
Automatic Data
Recovery: SCSI
Port 1: SCSI ID 0
Select F1 to continue
with recovery of data
to drive. Select F2 to
continue without
recovery of data to
drive.
-Or-
Slot 1 Drive Array
Recovery Needed.
Automatic Data
Recovery Previously
Aborted! The
following SCSI
drive(s) need
Automatic Data
Recovery: SCSI
Port 1: SCSI ID 0
Select F1 to retry
Automatic Data
Recovery to drive.
Select F2 to continue
without starting
Automatic Data
Recovery data to
drive data to drive.
1787-Drive Array
Operating in Interim
Recovery Mode.
Physical drive
replacement needed:
Drive X
continued
Audible Beeps Probable Source of Problem
None System in Interim Data Recovery
mode. Data has not yet been
recovered.
None Hard drive X failed or cable is
loose or defective. Following a
system restart, this message
reminds you that drive X is
defective and fault tolerance is
being used.
Recommended Action
Press F1 to allow Automatic
Data Recovery to begin. Data is
automatically restored to drive X
once the drive has been
replaced or seems to be
working.
-Or-
1. Press F2 for the system to
continue to operate in the
Interim Data Recovery
mode.
The "previously aborted"
version of the 1786 POST
message displays if the
previous rebuild attempt
was aborted for any
reason.
2. Run Array Diagnostic
Utility (ADU) for more
information.
If the replacement drive
was failed, try using
another replacement drive.
-Or-
If rebuild was aborted due
to a read error from
another physical drive in
the array, back up all
readable data on the array,
run Diagnostics Surface
Analysis, and then restore
your data.
1. Replace drive X as soon as
possible.
2. Check loose cables.
3. Replace defective cables.
continued