Table of Contents
Advertisement
4. Press the release button 1 to release the secondary hard disk drive cage and
then lift the cage out of the chassis.
Figure 19. Removing the secondary hard disk drive cage
5. Pull on the handle to release and remove the blue hard disk drive bracket
from the hard disk drive cage.
6. To install the new hard disk drive into the blue bracket, flex the sides of the
bracket properly and align pin 1 , pin 2 , pin 3 , and pin 4 on the
bracket with the corresponding holes in the hard disk drive. Do not touch the
circuit board 5 on the bottom of the hard disk drive.
Note: If you are installing a 2.5-inch hard disk drive, install the hard disk
drive into a 2.5-inch to 3.5-inch hard disk drive tray first and then install the
tray into the blue bracket.
Figure 20. Installing the hard disk drive into the bracket
Chapter 5. Installing or replacing customer replaceable units
29
Advertisement
Table of Contents
