Table of Contents
Advertisement
10. Connect the heat sink and fan assembly cable to the microprocessor fan
Replacing the primary hard disk drive
This section provides instructions on how to replace the primary hard disk drive.
To replace the primary hard disk drive, do the following:
36
Installation and User Guide
connector on the system board. See "System-board internal connectors" on
page 14.
What to do next:
v To work with another piece of hardware, go to the appropriate section.
v To complete the replacement, go to "Completing the parts replacement" on
page 44.
Attention
Do not open your server or attempt any repair before reading and
understanding the "Safety" on page v and the Safety Information book. To
obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 18.
3. Locate the primary hard disk drive. See "Internal drives" on page 16.
4. Disconnect the signal cable and the power cable from the rear of the hard disk
drive.
Advertisement
Table of Contents
