Canon CanoScan FB 1200S User Manual page 14

CONTENTS
GLOSSARY
INDEX
Selecting ScanGear CS-S
ScanGear CS-S can be called from any TWAIN-compliant application, such as
an imaging or OCR application.
Because the TWAIN-compliant application may install older TWAIN files than
ScanGear CS-S's, it is recommended that the application be installed first,
before ScanGear CS-S.
If you have installed other TWAIN drivers on your computer, you may select it
as your default TWAIN source by using the application's 'File/Acquire/Select
TWAIN_32 Source' menu option or its equivalent. Once you have selected
ScanGear CS-S as your source, choosing the command to scan, such as 'File/
Acquire', or 'File/Scan' will automatically start ScanGear CS-S in the
application.
Removing ScanGear CS-S
If you need to remove ScanGear CS-S from your system, use the following
steps to make sure all files are removed from all locations.
To remove ScanGear CS-S from your computer:
1. Place the CanoScan Setup CD-ROM in the computer drive.
2. In the start-up menu, click [Install/Uninstall Software].
3. [Install] window is displayed. Check the check box for [ScanGear CS-S] and
click [Uninstall] in the top-left of the window.
4. Click [Open the Add/Delete Programs dialog] in the bottom-right of the
window.
5. In the [Add/Remove Programs Properties] dialog box, make sure the
[Install/Uninstall] tab is in front, then select Canon ScanGear CS-S 4.3 and
click [Add/Remove].
6. Click [Yes] to confirm that you want to delete ScanGear CS-S.
Windows removes ScanGearCS-S and all its associated unused files.
Note: You may be asked a question about removing shared files
that are no longer in use. It is OK to click 'Yes' to these
questions.
Chapter 2
Installing ScanGear CS-S 4.3
14
14