Table of Contents
Advertisement
6.2.5
6.2.5
6.2.5
Rebuilding failed drives
Rebuilding failed drives
Rebuilding failed drives
6.2.5
6.2.5
Rebuilding failed drives
Rebuilding failed drives
You can manually rebuild failed hard disk drives using the R e b u i l d
command in the Management Menu.
To rebuild a failed hard disk drive:
1.
From the Management Menu, highlight R e b u i l d
2.
The P H Y S I C A L D R I V E S S E L E C T I O N M E N U
P H Y S I C A L D R I V E S S E L E C T I O N M E N U displays the available
P H Y S I C A L D R I V E S S E L E C T I O N M E N U
P H Y S I C A L D R I V E S S E L E C T I O N M E N U
P H Y S I C A L D R I V E S S E L E C T I O N M E N U
drives connected to the SATA ports. Select the drive you want to
rebuild, then press <SpaceBar>.
A S U S T S 3 0 0 - E 3
A S U S T S 3 0 0 - E 3
A S U S T S 3 0 0 - E 3
A S U S T S 3 0 0 - E 3
A S U S T S 3 0 0 - E 3
R e b u i l d
R e b u i l d
R e b u i l d
R e b u i l d
R e b u i l d
R e b u i l d
R e b u i l d, then press <Enter>.
R e b u i l d
6 - 2 3
6 - 2 3
6 - 2 3
6 - 2 3
6 - 2 3
Advertisement
Table of Contents
