Dish Network 6.3 User Manual page 24

1 to control the TV2 side of your receiver.
Note: Highlight the
area in the graphic above).
7 Press the RECORD button on the green TV1 remote control you
are setting up. If you get a warning that tells you to pick another
address, continue on to the next step. If no warning appears, go to
step 12 of this procedure.
8 On the remote control, press and hold the SAT mode button for
about three seconds, until all the mode buttons light up, and then
let go of the SAT button. The SAT mode button will blink.
9
Use the number buttons to enter any number from 1 to 16, except
for the address shown for
Write down the number you entered:
10 Press the POUND (#) button. If you entered the address correctly,
the SAT mode button will flash three times.
11 Make sure the System Information screen shows
that this address matches the number you entered in step 9.
12 Select Done to close the System Information screen. If
nothing happens, press RECORD, and then select Done.
Remote Addrs.
i 1
TV Out
UHF
Remote Address (the shaded
on your screen.
5
3
UHF and
12