Dish Network 6.3 User Manual page 17

Instructions
2
Press and hold the mode
button until all the other
mode buttons light up, and
then let go of the button.
The mode button flashes.
3 For AUX mode only. Press
0 for a second TV, or 1 for
a second VCR, or 2 for a
tuner, or amplifier. Then
press the STAR (*) button.
4 Press POWER.
5 Press the UP or DOWN
ARROW repeatedly until
the equipment turns off.
6 Press POUND (#).
7
Turn the equipment back
on and try some other but-
tons to make sure they
work.
5
Additional Information
For example, hold TV for a TV
until all of the other mode
buttons light. When you let go,
TV will flash.
This step is for programming
which kind of equipment that
should be programmed in AUX
mode. If you're not
programming in AUX mode,
skip to step 4.
This puts your remote in the
scan mode.
As you press the UP or DOWN
ARROW, the remote tries each
code in the memory to see if it
can turn off your equipment.
When the equipment turns off,
you have found a code that
might work.
Note: The mode button for the
equipment will flash rapidly
eight times when you've
scanned all the codes for that
equipment.
The mode button flashes three
times if you have entered the
code correctly. This stores the
code you found.
Press POWER to turn the
equipment back on. Try some
other buttons to make sure they
work. Sometimes POWER
works when other buttons
don't.